New OLT Initial Configuration - ZTE

Video Tutorial

Step-by-Step Manual

Note:

The following steps are for a new ZTE OLT or one that has been reset to factory settings.

To better understand how the OLT connection is structured when performing the configuration, you can rely on the following diagram, which shows the physical connection.

1 We must check that we have internet access.

2 We must have our VLAN, Management LAN, and Client Segment LAN created.

1.- We add the default segment of the OLT: 136.1.1.254/24 so that the Mikrotik can communicate with the OLT
2.- We add the OLT Management LAN: 192.168.20.0/24, later we will assign the IP 192.168.20.80 to the OLT
3.- We add a VLAN where we assign our Network Segment for the ONUs: 192.168.44.0/24 (sfp port or ethernet port depending on the case).
4-. The VLAN will be assigned to the UPLINK port of the ZTE OLT

3 We must test the connection with the OLT using the default assigned IP.

4 We connect via Telnet with the Default IP


    /sys telnet 136.1.1.100
    zte
    zte

5 We proceed to add the Chassis/Rack.


	# C320 OLT
	conf t
	set-pnp enable
	add-rack rackno 1 racktype C320Rack
	add-shelf rackno 1 shelfno 1 shelftype C320_SHELF


	# C300 OLT
	conf t
	set-pnp enable
	add-rack rackno 1 racktype IEC19
	add-shelf rackno 1 shelfno 1 shelftype IEC_SHELF

6 We configure the new IP of the OLT


	interface mng1
	ip address 192.168.20.80 255.255.255.0

Note:

The session will end due to the IP change, therefore, you will need to log in again with the IP from the previous command. As in step 7.

7 Now we can connect with the new IP. For this, we will use the following command.


	/sys telnet 192.168.20.80

8 Once the connection is established, we will proceed to configure the default routes.


	conf t
	no ip route 0.0.0.0 0.0.0.0
	ip route 0.0.0.0 0.0.0.0 192.168.20.1
	exit
	write

9 Create a new user that allows AdminOLT to connect to your equipment via Telnet.


	conf t
	username myuser password mypassword max-sessions 15 privilege 15

User and Password Length

The users used in this guide are for example. Please use a longer username and password for better security.

Once all of the above has been completed, you must configure the rules of your MikroTik. You can get the Script in the OLT's section of the system.

Note:

Next step, add the ZTE OLT Add ZTE OLT

April 12, 2024, 3:32 p.m. - Visitas: 55180