Configuration on MikroTik RouterBoard for OLT Vsol Single PON
Note
Router with Internet Output
Connection through Ethernet port.
Bridge Creation
We are going to create a bridge to assign an IP from the default administration network of the OLT and also be able to assign an IP when we change the default network.
1 Go to the Bridge section in the RouterBoard menu to create the bridge1 interface and thus be able to group the ports that will be working on the OLT network.
2 Assign the two ports connecting to the OLT to bridge1.
Vlan Creation for Hosts
1 Go to the interface configurations and to the Vlan section, where you will create a vlan named vlan300 with ID 300, which will be where the subnet for hosts will be created.
IP Addressing
1 In IP Address, assign the IP to each interface as shown in the following images, which are based on the topology shown at the beginning of the manual.
2 IP addressing for the default Administration network. This is the network that comes in new Vsol OLTs or those that have been reset to default values. This IP will only serve us to connect to the equipment for the first time, as later in the OLT configuration we will change it to our administration network.
3 IP addressing for the administration network. This will be the IP we use to work on our new administration network.
4 LAN IP addressing for OLT Vsol. This address will be the Gateway for the LAN network for Hosts (ONUs) of Vlan300, which will serve us to give addressing statically, through DHCP, or through a PPPoE server.
Next Step
April 12, 2024, 3:32 p.m. - Visitas: 4736